Exercise Library

Exercise Library

Category: Core

Dead Bug

Laying on the back, arms go straight into the air and legs come up to a 90-degree angle.  Maintaining a neutral spine, extend one leg and the opposite arm in a slow and controlled manner. Come back to the starting position and do the same with the other leg and arm.

Dead Bug

How to perform:

Dead Bug

Dynamic control is the ability to control the core under challenging conditions such as instability or a disadvantageous position against gravity. In most cases, this is the ability to avoid bending the lower spine backward (lumbar extension). The dead bug is an exercise that looks simple but is actually quite hard. It teaches to hold the spine neutral when it wants to bend (anti-extension).


The starting position for the dead bug is laying on the back, head on the ground with arms straight up in the air and legs up in the air bent at 90 degrees. There may be a noticeable gap from the low back and the ground which is not wanted. Contract the abs to eliminate the space of the lower back and the ground. Throughout the entire movement maintain tight consistent contraction of the abdominals, as well as a flat back against the floor focusing on the lumbar region.

If there is trouble engaging the core to specifically flatten the lower back, try slipping a hand underneath so the pressure being exerted can be felt.


Once the core is properly engaged and there is no gap between the lumbar spine and the floor, extend one leg out simultaneously with the opposite arm. They should move in a slow and controlled manner. Doing this makes it harder to control the core, so only go as far as possible while maintaining a flat back. Slowly bring the arm and leg back into the starting position and do the same with the other arm and leg. Repeat this for a set amount of time instead of counting reps.



Protocol:

Complete 3 sets performing 60 second of the movement for each set

Share This Exercise:

List of Services

Share by: